Your tutorials look great and you state the information generated can be used for estimating. However, the wall tool with two top plates and a single bottom plate work
great if the wall is placed on top of another wall. But what about the wall on wood joists which sit on a concrete foundation. The joists need to sit on a mud sill (2x6
pressure treated wood). It would be great to have the option to place the mud sill component directly under the end of the joists/rim board using the joist floor tool.
It would seem a waste of time to have to copy and paste or create a mud sill below the floor joists when this could be done automatically. Is there a way to do this?
The tutorials seem too general and avoid this.