Page 1 of 1

Cladding to end of wall

PostPosted: Sun Apr 29, 2018 9:56 am
by SketchHouse
I was wondering if there was a way for Plusspec to automatically clad the free end of a length of wall?

Re: Cladding to end of wall

PostPosted: Mon May 07, 2018 5:07 pm
by Grant
Hi SketchHouse

Thank you for your post.

It sounds like the Wall Surface Tool would be helpful here but I'm not quite sure where you're referring to. Would you be able to please send over either a screenshot or image of this?