Page 1 of 1

doors

PostPosted: Wed Apr 18, 2018 12:02 pm
by MylesG
hi guys,

got this problem with the doors.
The doors are not the correct size for the width of the walls. wall width is 90mm finish to finish the doors are generating at 130mm inside architrave to inside architrave.
door.JPG
door.JPG (85.77 KiB) Viewed 2089 times


thanks

Re: doors

PostPosted: Wed Apr 18, 2018 12:21 pm
by MylesG
I also changed the wall timber from 90 down to 70 prior to fitting off the door. but I also have a problem with doors where I haven't changed the timber size.

Re: doors

PostPosted: Thu Apr 26, 2018 12:43 pm
by Grant
Hi Myles,

Thank you for your post.

What I would recommend to do is to go to the 'Manual Overrides' section of the Wall Tool and check that the 'Cavity' field is set to 0. This will normally happen when using the 'Create Similar Wall' option when you right click on a wall as it takes all values from the original wall to create the next wall.

Would you be able to please let me know if this fixes the issue you're having?