Moderators: Daniel, Emily
I have noticed that when drawing tall walls, the software doesn't allocate/draw and noggins over the lintels of doors and windows.
- Posts: 7
- Joined: Sat Nov 27, 2021 10:17 am
Yep trueline that might be the case, I will have to check. It may also be that the maximum spacing of the nog may not be reached as the lintel is higher than the bottom plate, and the spacing should start from the top of the head. It would be rare to have 1300mm above a head, right?
- Posts: 321
- Joined: Thu Aug 08, 2013 1:30 pm
Return to PlusDesignBuild
Who is online
Users browsing this forum: No registered users and 1 guest