I have this model that was done just with sketchup (see bottom image). It is a split level design with the top floor roof also forming part of the lower roof. I have done face for the upper roof and lower roof but it ends up with part skillions and part hip roof (see top image). When I try and turn the hip into a gable on the lower section at the back where the first floor roof is meant to come down I end up with a weird shape all over the model. Does anyone know how I can do this roof with Plus Spec?
PJ Scott Homes
- initial roof 1.jpg (133 KiB) Viewed 2696 times
- sketup basic model 1.jpg (95.47 KiB) Viewed 2696 times