New Here, With Question

Welcome! Ask and get answered - or just introduce yourself.

Moderators: Daniel, Emily

New Here, With Question

Postby Kj5200 » Wed Apr 27, 2022 10:23 am

Hello all,

I love the software but I might be overloaded with Info because I feel like I've seen the answer to my question but not sure where...

How do I change the bottom plate in the wall tool? When I build walls on a concrete slab, I need the bottom plate to be treated 2x4 or 2x6 and need it to be captured on the estimation.


Thanks,

Kenneth
Kj5200
 
Posts: 10
Joined: Wed Apr 27, 2022 10:15 am

Re: New Here, With Question

Postby Kj5200 » Wed Apr 27, 2022 11:27 am

Apparently i just needed to post the question to figure it out an hour later, LOL...

Kenneth
Kj5200
 
Posts: 10
Joined: Wed Apr 27, 2022 10:15 am

Re: New Here, With Question

Postby Emily » Thu Apr 28, 2022 9:33 am

;0 . . .good for you!
User avatar
Emily
PlusSpec Developer
 
Posts: 117
Joined: Sat Jul 12, 2014 8:27 pm

Re: New Here, With Question

Postby Kj5200 » Fri Apr 29, 2022 5:01 am

I have question about using Wall Junction tool... I am adding interior walls perpendicular to my exterior wall. I created Ladder Junction so there is blocking with access to add insulation. However when doing that option, it does not cut the drywall and trim. Is there a way to do this?

Thanks,

Kenneth
Kj5200
 
Posts: 10
Joined: Wed Apr 27, 2022 10:15 am

Re: New Here, With Question

Postby Emily » Tue Jun 28, 2022 12:03 pm

Hi, Keneth I just test that and I did not see it, I'll see if I can find out why.
User avatar
Emily
PlusSpec Developer
 
Posts: 117
Joined: Sat Jul 12, 2014 8:27 pm

Re: New Here, With Question

Postby Grant » Fri Jul 01, 2022 11:09 am

Hi Kenneth,

Currently, only the 'Standard Junction' option will cut the internal linings.

If you want to cut the internal lining or trimming of the wall it needs to be done manually using SketchUp tools. Please note that any manual edits will be removed when the wall is edited using a PlusSpec tool, so we recommend only doing manual edits once no further edits are needed or at the end of the job.

Hope this helps.
Kind Regards,
Grant
User avatar
Grant
Site Admin
 
Posts: 363
Joined: Thu Aug 08, 2013 1:50 pm


Return to New Users - Welcome to the 'Speccas' Community!

Who is online

Users browsing this forum: No registered users and 3 guests