Roof Tool... no roof formed on equal size cruciform plan

Hi Andrew and Team,

Possible bug with roof tool as follows.

I have been working on a “cruciform/cross” type plan where the house basically has north, east, west and south wings radiating from the same central point. If the width of each wing is identical Plusspec will not create a pitched roof.

If one wing is differing in width by as little as 1mm a roof will form. Or if wings remain same width but one is offset from the central position roof will form.

Looking forward to your opinions.

Zorro

crucifrom_roof_001.jpg

crucifrom_roof_002.jpg

crucifrom_roof_003.jpg

Hi Zorro,

Thanks for bringing this to our attention.

I’ll test it out on my machine and then pass it onto the Developers to look into

Thanks,

Dan