Roof Tool... no roof formed on equal size cruciform plan

Post any found bugs here.

Moderator: Daniel

Roof Tool... no roof formed on equal size cruciform plan

Postby zorro » Sun Jul 13, 2014 2:16 pm

Hi Andrew and Team,

Possible bug with roof tool as follows.

I have been working on a "cruciform/cross" type plan where the house basically has north, east, west and south wings radiating from the same central point. If the width of each wing is identical Plusspec will not create a pitched roof.

If one wing is differing in width by as little as 1mm a roof will form. Or if wings remain same width but one is offset from the central position roof will form.

Looking forward to your opinions.

Zorro

crucifrom_roof_001.jpg
crucifrom_roof_001.jpg (36.8 KiB) Viewed 2469 times


crucifrom_roof_002.jpg
crucifrom_roof_002.jpg (45.03 KiB) Viewed 2469 times


crucifrom_roof_003.jpg
crucifrom_roof_003.jpg (42.52 KiB) Viewed 2469 times
zorro
 
Posts: 37
Joined: Wed May 07, 2014 7:02 pm
Location: New Zealand

Re: Roof Tool... no roof formed on equal size cruciform plan

Postby Daniel » Mon Jul 14, 2014 10:05 am

Hi Zorro,

Thanks for bringing this to our attention.

I'll test it out on my machine and then pass it onto the Developers to look into

Thanks,

Dan
Daniel
PlusSpec Developer
 
Posts: 62
Joined: Tue Jun 03, 2014 4:10 pm


Return to Bugs

Who is online

Users browsing this forum: No registered users and 3 guests