Wall cleanups

Post your discussions and questions about PlusSpec here.

Moderator: Daniel

Re: Wall cleanups

Postby Andrew » Mon Oct 20, 2014 9:02 am

Hi Drew I agree. I have come across this before. I think adding a wall end function is achievable, this may also alleviate the mitred corner when having two different wall heights.
In the short term as a work around, select view hidden geometry & unhide where required. Note for other users this will only happen when the wall is behind the section cut a section cut will automatically create a line on a cut wall.
There is a reason for this as Splitting a wall would add vertical lines on elevations.
Posts: 282
Joined: Thu Aug 08, 2013 1:30 pm


Return to General Discussion and Questions

Who is online

Users browsing this forum: No registered users and 3 guests